Great Plains DVN8324 Operator Manual - Manual (Page 42)

38 8315-8324DVN Great Plains Manufacturing, Inc.
550-466M 11/25/2013
Side to Side Leveling
Refer to Figure 29
2. Set the wings to match the depth of the center. This is
done by adjusting the lift cylinder eyebolt on each wing.
Lengthen the bolt to run shallower, shorten the bolt to
run deeper.
Refer to Figure 30
Disc Gang Depth Calibration
3. Be sure the pre-load is set at 22.23 cm (8.75 in) on the
spring assemblies. Calibrate the depth gauge pointer
by extending cylinder until the under frame clearance
of the 50.8 cm (20 in) blades is 11.43 cm (4.5in). Place
the decal on the stand with the pointer at ‘0’.
Figure 29
Wing Depth Adjustment
41594
Figure 30
Disc Gang Depth Gauge Calibration
41599