Troubleshooting, General performance, Troubleshooting general performance – Great Plains DVN8324 Operator Manual User Manual

Page 60

Advertising
background image

550-466M

11/25/2013

56

8315-8324DVN

Great Plains Manufacturing, Inc.

Troubleshooting

General Performance

Problem

Cause

Solution

Rear Shanks Leaving
Groove

Rear of machine running too deep.

Coulter/disc gangs too deep.
Drag set incorrectly.
Operating machine too fast.

Level machine from front to rear with turn-
buckle, See “Front to Rear Leveling” on
page 37
Raise disc gangs.
Reset drag, See “Rear Attachment Set-
tings
” on page 40.
Slow down (9-11 km/h)/(6-7 m/h).

Leaving Ridges On
The Outside

Wings not level.

Lift cylinders out of phase.
Leaking wing lift cylinder.
Drag set Incorrectly.

Operating machine too fast.

Adjust eyebolt at rear of wing cylinders to
level wings. See “Side to Side Leveling” on
page 38.
Rephase lift cylinders.
Repair or replace leaky cylinder, See pages
34-37 of “Parts Manual”.
Reset drag, See “Rear Attachment Set-
tings
” on page 40.
Slow down (6-7 m/h)/(9-11 km/h)

Wings Not Penetrating Wings not level.

Coulter/disc gangs too deep.
Wing gangs deeper than center gangs.
Fold cylinder nor fully extended.

Adjust eyebolt at rear of wing cylinders to
level wings. See “Side to Side Leveling” on
page 38.
Raise disc gangs.
Rephase gang circuit.
Fully extend cylinders.

One Wing Running
Deeper Than The
Other

Wings not level.

Leaking wing lift cylinder.

Wing cylinder in wrong sequence.
Improper tire pressure.

Adjust eyebolt at rear of wing cylinders to
level wings. See “Side to Side Leveling” on
page 38.
Repair or replace leaky cylinder, See pages
34-37 of “Parts Manual”.
Repair or replace leaky cylinder, See pages
26-27 of “Parts Manual”.
Set air pressure, See “Tire Inflation Chart
on page 64.

Both Wings Running
Too Deep

Wings not level.
Improper tire pressure.

Adjust eyebolt at rear of wing cylinders to
level wings. See “Side to Side Leveling” on
page 38.
Set air pressure, See “Tire Inflation Chart
on page 64.

Whole Machine Runs
Deeper

Leaking depth stop cartridge.
Leaking master lift cylinder.

Replace cartridge.
Repair or replace leaky cylinder, See pages
26-27 of “Parts Manual”.

Center & One Wing
Run Deeper

Leaking master lift cylinder.

Repair or replace leaky cylinder, See pages
26-27 of “Parts Manual”.

Advertising
This manual is related to the following products: