Great Plains 3S-5000HD Assembly Instructions - Manual (Page 27)

Great Plains Manufacturing, Inc. Table of Contents Index Installation Instructions 23
2013-07-30 Table of Contents Index 133-415M
Remove Wind Shields
Refer to Figure 34
95. If the wind shields are pre-installed on the seed
cups, remove and save them, to prevent loss or
damage during seed box installation.
Squeeze the tabs at the top. Tilt the shield
backward and out. These are re-installed at
step 132 on page 31.
Mount Seed Boxes
Boxes are installed, RH box first, on each section.
Start with the left section:
Mount a RH Box Assembly
Refer to Figure 35
96. For a Left Wing, Select one of the following small
seed box assemblies , new:
133-394K 3S5000 SGS LW RH BOX ASY 6 IN
133-404K 3S5000 SGS LW RH BOX ASY 7.5IN
133-414K 3S5000 SGS LW RH BOX ASY 10 IN
For a Center Section, select one of new:
133-391K 3S5000 SGS CT RH BOX ASY 6 IN
133-401K 3S5000 SGS CT RH BOX ASY 7.5IN
133-411K 3S5000 SGS CT RH BOX ASY 10 IN
For a Right Wing, select one of new:
133-383K 3S5000 SGS RW RH BOX ASY 6 IN
133-397K 3S5000 SGS RW RH BOX ASY 7.5IN
133-407K 3S5000 SGS RW RH BOX ASY 10 IN
97. Select four sets of new:
802-388C HFS 3/8-16X1 GR5
804-013C WASHER LOCK SPRING 3/8 PLT
803-014C NUT HEX 3/8-16 PLT
98. Mount the box at the forward set of open holes in
the mounts and drives just installed.
Repeat step 96 through step 98 for the center and right
sections
Figure 34:
817-806C Wind Shield
34582
258
U
D
R
F
B
L
258
U
D
L
R
B
F
205
226
212 205
226
212
1
Figure 35:
Mount RH Small Seeds Assembly
34596
1
151
161
171
1
148
158
168
1
140
154
164
205
226
212
1