Great Plains DVN8552 Assembly Manual - Manual (Page 22)

18 8321-8552DV Great Plains Manufacturing, Inc.
550-353Q-ENG 02/12/2014
Install 8321-8324 Wings
Refer to Figure 10
43. Carefully align holes in wing frame LH
with holes in
center frame. Secure with 1 x 7 Gr. 8 special thread
hex bolt
and 1 nylon lock nut.
Note: Be sure and install the 1 x 6 hex bolts as shown
with arrows with head against plate on side of
hinge.
44. Attach wing brace to the front of the wing frame LH
with 3/4 x 2 Gr. 5 hex bolts , 3/4 lock washers
and 3/4 hex nuts.
45. Install 1 x 6 Gr. 5 hex bolts and 1 nylon lock nuts
through hinge in center wing brace.
Refer to Figure 11
Note: If you have a model 8324, go to Refer to Figure 12.
46. Align holes in wheel arm L , secure with 1 1/4 x 6
pins , 3/8 x 2 1/4 hex bolts and 3/8 top lock nuts.
47. Model 8321, align hole in 6-bolt spindle assembly
with wheel arm tube, secure with 5/16 x 2 13/16 clevis
pin
and 1/8 x 1 cotter pin, bend over to secure.
48. Attach tire/wheel assembly with lug nuts .
49. Repeat same procedure for right wing.
Refer to Figure 12
50. Align holes in wheel arm L
, secure with 1 1/4 x 6
pins , 3/8 x 2 1/4 hex bolts and 3/8 top lock nuts.
51. Install walking beams , See “Walking Beam
Assembly” on page 27.
52. Model 8324, align hole in 6-bolt spindle assembly
with tube of walking beam, secure with 5/16 x 2 13/16
clevis pin
and 1/8 x 1 cotter pin, bend over to
secure.
53. Attach tire/wheel assembly with lug nuts .
54. Install hub/wheel on other side of walking beam .
55. Repeat same procedure for right wing.
56. Tighten all bolts to specs, See “Torque Values
Chart” on page 43.
Figure 10
8321-8324 Wing
42330
2
4
3
1
U
D
F
B
L
R
1
2
2
3
1 4
2
Figure 11
8321 Hub/Wheel
42330
8 9
5
7
6
10
11
U
D
F
B
L
R 5
6 7
8
9
10 11
Figure 12
8324 Hub/Wheel
42330
14
16
12
18
13
17
15
19
U
D
F
B
L
R
12
13 14
19
15
16
17 18
19