Great Plains DVN8552 Assembly Manual - Manual (Page 44)

40 8321-8552DV Great Plains Manufacturing, Inc.
550-353Q-ENG 02/12/2014
Lights and SMV Assembly
Refer to Figure 44
201.Fasten light bracket LH to stub plate of center
frame with 1/2 x 1 1/2 Gr. 5 hex bolts , 1/2 lock
washers and 1/2 huts. Repeat same procedure for
light bracket RH
.
202.Attach light mounting brackets to rear side tube as
shown, of center frame, with 1/2 x 4 1/32 x 4 u-bolts
, 1/2 lock washers and 1/2 huts.
203.Attach smv post (models 8321-8333) to back side
of same tube as light mounting brackets , as close
to center as possible. Secure with 1/2 x 4 1/32 x 4 u-
bolts
, 1/2 lock washers and 1/2 huts. Attach smv
sign to back side of smv post , secure with 1/4 x
3/4 pan head screws , 1/4 lock washers and 1/4
nuts.
204.Route light harness 30’ lead from front of hitch
(tractor plug to front), along same route as hydraulic
hose (fasten in same clamps and hose wraps as
hoses). Plug one end of enhance light harness to
small end of light harness 30’ lead . Plug bigger
end of wishbone light harness into other end of
enhance light module . Route other ends over
towards (marked left and right) the light mounting
brackets as shown.
205.Mount red lamp lights to top of light mounting
brackets , with 1/4 x 1 Gr. 5 hex bolts and 1/4
lock nuts.
206.Mount amber lamp lights to top of light brackets
and , with 1/4 x 1 Gr. 5 hex bolts and 1/4 lock
nuts.
207.Tighten all bolts to specs. Be sure and get all wiring
harnesses fastened up securely with hose wraps or
clamps (if routed close to hydraulic hoses) or use
cable ties
.
1
3
2
4
5
6
4
5
7 6
8
9
10
9
11
10
12
4 14
13
1 2 14
15