Great Plains DVN8552 Assembly Manual - Manual (Page 26)

22 8321-8552DV Great Plains Manufacturing, Inc.
550-353Q-ENG 02/12/2014
Install 8537-8552 Inside Wings
Refer to Figure 15
78. Carefully align holes in wing frame LH
with holes
in center frame. Secure with 1 x 7 Gr. 8 special
thread hex bolt
and 1 nylon lock nut.
Note: Be sure and install the 1 x 6 hex bolts as shown
with arrows with head against plate on side of
hinge.
79. Attach wheel arm L , to wing frame secure with 1
1/4 x 6 pin , 3/8 x 2 1/4 hex bolts and 3/8 top lock
nuts.
80. Install walking beams , See “Walking Beam
Assembly” on page 27.
81. Align hole in 6-bolt spindle assembly , secure with
5/16 x 2 13/16 clevis pin and 1/8 x 1 cotter pin,
bend over to secure.
82. Attach tire/wheel assembly with lug nuts .
83. Attach wing brace to the front of the wing frame
LH with 3/4 x 2 Gr. 5 hex bolts , 3/4 lock wash-
ers and 3/4 hex nuts.
84. Attach wing lock mount with 1/2 x 3 1/32 x 5 u-
bolts , 1/2 lock washers and 1/2 nuts.
Note: See layout section for proper placement of lock
mount .
85. Mount automatic wing latch , using 3/4 x 4 1/2 hex
bolt and 3/4 lock nut.
86. Attach bolt-on stub , to wing frame plate, using 5/8
x 1 1/2 hex bolts , 5/8 lock washers and 5/8 nuts.
87. Repeat same procedure for right wing.
88. Tighten all bolts to specs, See “Torque Values
Chart” on page 43.
1
2
2
3 1
4 5
6
7
8
9 10
11
1 12
13
14
13
15
16
17
18