Great Plains 3S-4000HDF Predelivery Manual User Manual
Page 2
3S-4000HD
195-067Q
12/10/2009
Table of Contents
©
Copyright 2001, 2006, 2007. 2009 All rights Reserved.
Great Plains Manufacturing, Inc. provides this publication “as is” without warranty of any kind, either expressed or implied. While every precaution has been taken in the preparation
of this manual, Great Plains Manufacturing, Inc. assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use of the infor-
mation contained herein. Great Plains Manufacturing, Inc. reserves the right to revise and improve its products as it sees fit. This publication describes the state of this product at
the time of its publication, and may not reflect the product in the future.
Great Plains Manufacturing, Incorporated Trademarks
The following are trademarks of Great Plains Mfg., Inc.: Application Systems, Ausherman, Land Pride, Great Plains
All other brands and product names are trademarks or registered trademarks of their respective holders.
Printed in the United States of America.
Important Safety Information.................................... 1
Introduction ................................................................ 4
Document Family ......................................................... 4
Description of Unit........................................................ 4
Using This Manual ....................................................... 5
Definitions ................................................................ 5
Assembly and Setup Assistance.................................. 5
Preparation ................................................................. 6
Tools Required............................................................. 6
Pre-Assembly Checklist ............................................... 6
Assembly .................................................................... 7
Install Center Box on Frame ........................................ 7
Install Walkboards and Steps ...................................... 8
Install Center Walkboard.......................................... 8
Install Wing Walkboards .............................................. 8
Walkboards with Single Steps ................................. 8
Walkboards with Swing-Down Ladders.................... 8
Install Swing-Down Ladders .................................... 9
Install Swing-Down Ladder Mounts.......................... 9
Install Ladders........................................................ 10
Install Fixed Walkboard Steps ............................... 10
Install Reflectors and Decals ..................................... 11
Center and Inner Decals ........................................ 11
Fixed Step Decals .................................................. 11
Swing-Down Ladder Decals................................... 12
Other Assembly Items................................................ 12
Install Press Wheels .............................................. 12
Two Outlet Kit ........................................................ 13
Markers .................................................................. 13
Open Center Conversion ....................................... 14
Point Row Option ................................................... 14
Post Assembly Checklist............................................ 14
Hitch Selection....................................................... 15
Hitch Height ........................................................... 16
Electrical Connections ............................................... 17
Hydraulic Hose Hookup ............................................. 18
Bleeding Hydraulics ................................................... 19
Bleeding Opener Lift Hydraulics ............................ 20
Bleeding Fold Hydraulics ....................................... 21
Bleeding Transport Lift Hydraulics......................... 22
Bleeding Marker Hydraulics................................... 23
Leveling the Drill ........................................................ 24
Center Box Frame Leveling ................................... 24
Opener Frames...................................................... 24
Wing Box Alignment .............................................. 25
Align Transfer Drive Shaft...................................... 26
Truss Tube Tension............................................... 28
Toolbar Height ....................................................... 28
Opener-Frame Clearance...................................... 29
Install Final Accessories ............................................ 29
Acremeter Installation ............................................ 29
Shaft Monitor ......................................................... 30
Point Row Controller.............................................. 30
Scraper Installation ................................................ 30
Appendix .................................................................. 31
Specifications and Capacities.................................... 31
Tire Inflation Chart ..................................................... 31
Torque Values Chart ................................................. 32
Hydraulic Diagrams ................................................... 33
Transport Lift.......................................................... 33
Fold........................................................................ 33
Dual Markers ......................................................... 34
Single Marker......................................................... 34
Two Outlet Conversion .......................................... 35
Opener Lift: Standard Closed-Center .................... 36
Opener Lift: Optional Open-Center........................ 37
Point-Row .............................................................. 38