Great Plains 3S-4000HDF Predelivery Manual - Manual (Page 29)

Setup 27
12/10/2009 195-067Q
Refer to Figure 34 and Figure 35
3.
To align the clutch jaws from front to rear, loosen
the two 1 ⁄
2
inch carriage bolts and slide breakaway
clutch bracket in the desired direction.
4. To adjust clutch jaws for full jaw contact, loosen the
same two
1 ⁄
2
inch carriage bolts and slide break-
away clutch bracket until jaws on the fixed half of
clutch make full contact with jaws on spring loaded
half of clutch without compressing clutch spring.
Note: The two 7 ⁄
8
inch hex shafts should have 1 ⁄
8
inch
(3.2mm) gap between them when the clutch jaws
have full contact.
Figure 34
Transfer Drive Shaft Gap
18955
2
1 7 7
Figure 35
Transfer Drive Shaft Horizontal Adjustment
18954
5
4
6
1
5
7
7
1
5
6
5
6
7
2