Great Plains 3S-4000HDF Predelivery Manual - Manual (Page 9)

Assembly 7
12/10/2009 195-067Q
Assembly
Install Center Box on Frame
Refer to Figure 3
1.
Unload mainframe/wing assembly from truck and
place it in a location that allows for wing unfolding (21
feet (6.4m) either side of implement centerline; 42
feet (12.8m) total span).
If markers were ordered, allow 46 ft (14m) either side
of implement centerline; 92 ft (28m) total span.
2. With forklift chains secured around lifting bar on back
of center section box
, lift center section box up to
folded drill.
3. Bolt center section to drill tongue as shown using 8
sets of
7 ⁄
8
inch bolts , flat washers, lock washers and
nuts .
4. Connect truss tubes to center section as shown
using clevis pins . Secure clevis pins with cotter
pins provided. Take looseness out of truss by adjust-
ing turnbuckles
on each truss tube, but do not
overtighten.
1
2
3
4
5
4 5
Figure 3
Mount Center Box
19115
7
6
1
2
3
5
6
7