Great Plains 7336 DH Predelivery Manual - Manual (Page 13)

Great Plains Manufacturing, Inc. Assembly 9
2014-06-25 556-235Q
Center Frame Gang Assembly
Refer to Figure 6
Note: The gang assemblies
will be marked as to the
location on disk as “left, front, center”. This would
refer to the left, front gang on the center section.
You may also refer to the machine layout section
for placement. The gang assembly will be the
same on both the narrow and wide center.
13. Remove the 1” x 3” Gr. 8 hex bolts . Align holes in
plates of gang assemblies to center frame plates
, secure with 1” x 3” Gr. 8 hex bolts , 1” lock
washers and 1” nuts.
14. Bolts may be tightened to specs, See “Torque Val-
ues Chart” on page 19.
1 3
1
2 3
Figure 6
Wide Center Frame
43448
1
2
1
3