Great Plains 7336 DH Predelivery Manual - Manual (Page 22)

18 Series II Disk Harrow Great Plains Manufacturing, Inc.
556-235Q 2014-06-25
C-Shank Alignment-Disc Gang Assembly
Refer to Figure 18
53. If gangs are removed from the gangbar for mainte-
nance, care must be taken to re-align the parts cor-
rectly during re-assembly. See figure below for the
proper C-shank alignment dimensions and pre
assembly procedures.
54. At this time the unit should be checked over for any
loose bolts. Air pressure in the tires should be
checked, See “Tire Inflation & Warranty” on
page 20. Refer to the lubrication section of the
“Operators Manual” for the lubrications for this
machine. If there is any rear attachment, it should be
installed at this time.
If machine is equipped with a rear attachment, be sure you
install the rear jack stand, see “Parts Manual” Rear Jack
Stand, so machine doesn’t tip backwards when unhooking
machine from tractor.
55. Once the options are installed, fold the Disk Harrow
to check for clearance and interferences, also watch
that hoses do not get pinched.
Note: Double check that all bolts are tightened to specs,
See “Torque Values Chart” on page 19.Consult
the “Operator’s Manual”, for the first time field
adjustments before going to the field.
1
4
3 2
Figure 18
C-Shank Alignment-Disc Gang
43464