Great Plains 7336 DH Predelivery Manual - Manual (Page 14)

10 Series II Disk Harrow Great Plains Manufacturing, Inc.
556-235Q 2014-06-25
Wing Hub and Wheel Assembly
Refer to Figure 7
Note: Remove the assembly stands from center section
and allow unit to rest on the ground in the center of
work area.
15. Set pre-assembled wing frame section on stands
that are tall enough to allow for installation of the
pre-assembled gang bars.
16. Remove the
1 ⁄
2
” x 4
1 ⁄
2
” hex bolts and slide in the
hub/spindle assembly to walking beam
assembly secure with the
1 ⁄
2
” x 4
1 ⁄
2
” hex bolts ,
secure with
1 ⁄
2
” lock washers and
1 ⁄
2
” nuts.
Note: Install tire/wheel (12.5Lx15, tire/wheel assem-
bly) to hub assembly with
9 ⁄
16
” lug nuts .
17. Bolts may be tightened to specs, See “Torque Val-
ues Chart” on page 19
1
3
2
4
5
6
7
Figure 7
Wing Hub and Wheel
41617
1
2
4
3
5 4
6
3 7