Great Plains DVN8552 Parts Manual - Manual (Page 47)

Revision Comments Part Description Part No. Ref.
Image No. dwg40882
CENTER PIVOT SPINDLE 2.75 550-349H 1.
HEAVY WALKING BEAM RH 550-347H 2.
(shown) HEAVY WALKING BEAM LH 550-348H 2.
CENTER SPINDLE SLEEVE 550-489D 3.
SEAL 2.50IDX3.88ODX.47T 816-574C 4.
BRG CONE 2.17ID JM207049 822-230C 5.
BRG CUP JM207010 822-229C 6.
WASHER MACH 2.25 X 1.50 X 10GA 804-063C 7.
NUT HEX SLOTTED 1 1/2-12 PLT 803-239C 8.
PIN COTTER 1/4 X 3 PLT 805-115C 9.
See 8-Bolt Hub & Spindle Assembly
for parts
HUB 8-BLT SPNDL 2.75X14.63 608 815-302C 10.
HHCS 1/2-13X4 1/2 GR5 802-413C 11.
NUT HEX TOP LOCK 1/2-13 PLT 803-342C 12.
WHEEL 15X10 8 BOLT WHITE 814-223C 13.
TIRE 12.5LX15 LOAD F 814-227C 14.
Includes items 13-14 TIRE/WHL 12.5LX15 LD F WHT GYR 814-236C 15.
NUT LUG 5/8-18 X 90 DEG PLT 803-219C 16.
GREASE ZERK 1/4-28 THD FORMING 800-080C 17.
05/08/14 - 47 - 550-353P
Table of Contents Part Number Index
Section 3: Transport
Center Walking Beam, 8544 (S/N 1382DD+) & 8548-8552 (S/N 1422DD-)
(Applies to 8544DV, 8548DV, 8552DV only)