Planting, Seed monitor, Parking – Great Plains CTA4000 HD Operator Manual User Manual
Page 41: Storage, Planting seed monitor, Parking storage
Great Plains Manufacturing, Inc.
Operating Instructions
37
2012-11-28
160-037M
Planting
Be aware of the 5 to 10 feet (1.5-3 m) of
implement-lowered operating distance required for seed
to reach the row units.
If you stop in the middle of a pass, raise the implement
and back up 10 feet (3 m) before resumption of seeding.
Seed Monitor
The seed monitor, included with the air cart, performs the
following functions:
On the implement:
• Implement lift switch monitoring
• Seed flow blockage (optional)
• On the Air Cart:
• Fan Speed monitoring
• Hopper material level monitoring
• Hopper air pressure monitoring (ADC2350 only)
• Meter rate monitoring (ADC2350 only)
• Ground speed monitoring
Consult the DICKEY-john
®
manual for how to configure reporting and alerts.
Parking
Following these steps when parking the implement for
periods of less than 36 hours. For longer periods, see
Storage, the next topic.
1.
Spot the implement on firm, level ground.
2.
Raise the implement. Fold as necessary for the
parking space available.
3.
Set the Transport/Field valve handle to TRANS.
4.
Perform the air cart parking checklist.
5.
Securely block cart tires to prevent rolling.
Storage
If possible, leave the cart and implement connected for
extended storage.
Store the cart and implement where children do not play.
If possible, store them inside for longer life.
1.
Perform the cart Storage checklist.
2.
Perform the implement Parking checklist.
3.
Lubricate the implement at all points listed under
“Lubrication” on page 57.
4.
Check all bolts, pins, fittings and hoses. Tighten,
repair or replace parts as needed.
5.
Check all moving parts for wear or damage. Make
notes of any parts needing repair before the next
season.
6.
Plug or cap seed delivery tubes to prevent pest entry.
7.
If the cart is disconnected from the implement for
storage, plug all 2
1
⁄
2
inch (64 mm) openings to
prevent pests from entering and nesting.
8.
Use touch-up paint to cover scratches, chips and
worn areas to prevent rust.