Great Plains NTA3510 Installation Instructions - Manual (Page 14)

Great Plains Mfg., Inc.
14 Blockage Monitor Kits
168-414M 10/29/2008
Refer to Figure 29
28. Select one each:
467980141 10’ EXT HARNESS
467980360 3’ REAR HITCH HARNESS
Interconnect these cables.
29. Connect the new cable assembly ( + ) to the
existing cart WSMT harness .
Refer to Figure 30
30. Route the extended cart harness along the right
lower frame tube, up the right rear angled corner
tube, and left across the upper rear tube.
Mount the receptacle end of the harness in the
available large hole
at the inside (electrical) bulk-
head at the left rear of the cart.
Secure the harness with ties.
CTA: Complete Drill Harness
Refer to Figure 31 and Figure 32 on page 15
31. Select one new:
467980131 20’ HITCH HARNESS
Route the single-connector end from the cart elec-
trical bulkhead
. Leave ample slack for hitch
movement.
Follow the left wing hydraulic hoses to the Tower 1
WSMB harness. Leave ample slack near the wing
pivots for folding.
Join the two-connector end to the WSMB harness
at Tower 1. Secure hitch harness with ties.
Figure 29: CTA:
Extend Cart Harness
26400
38
35
95
96
91
35
38
35 38
96
Figure 30: CTA:
Cart Harness Extension Routing
28432
35
38
U
D
F
B
L
R
1
1
Figure 31: CTA:
Hitch Harness Routing
17186
T1
U
D
F
B
L
R
33
33
1
40