Great Plains 3P600 Operator Manual - Manual (Page 49)

Great Plains Manufacturing, Inc. Table of Contents Index Appendix B - Pre-Delivery 45
2011-10-21 Table of Contents Index
Install SMV Reflector
SMV on Model 3P500, 3P600 (and 3P500V
with Walkboard Option)
Refer to Figure 28
The SMV reflector
is shipped pre-assembled to the
mount , but mounted inverted on the walkboard. The
SMV must be repositioned to upright to prevent contact
with row units during operation.
Remove and save two sets:
802-007C HHCS 5/16-18X3/4 GR5
804-009C WASHER LOCK SPRING 5/16 PLT
803-008C NUT HEX 5/16-18 PLT
Orient the reflector assembly upright, and red/orange
reflective side to rear. Secure mount to walkboard
with bolts , lock washers and nuts .
SMV on Standard Model 3P500V
If also installing a walkboard (page 50), install the SMV
first.
Refer to Figure 29
1.
Select one each:
123-524D SMV MOUNT BRACKET, EXTENDED
806-004C U-BOLT 3/8-16 X 2 X 2 3/4
and two sets:
804-013C WASHER LOCK SPRING 3/8 PLT
803-014C NUT HEX 3/8-16 PLT
Mount the bracket at the center of the rear face of
the rear cross tube under the seed box. The short
break is down and forward. Secure with U-bolt
,
lock washers and nuts .
2. Select one:
818-055C DECAL SLOW MOVING-GALV. BACKED
and two sets:
802-004C HHCS 1/4-20X3/4 GR5
804-006C WASHER LOCK SPRING 1/4 PLT
803-006C NUT HEX 1/4-20 PLT
Orient the reflector upright, and red/orange
reflective side to rear. Secure reflector to mount
to walkboard with bolts
, lock washers and
nuts
Figure 28
Walkboard SMV Reflector
32648
29
44
32
26
48
44
48
26
32
29
48
48
26 32 29
Figure 29
3P500V SMV Reflector
32717
35
44
16
30
34
28
31
25
16
35
34
30
16
35
34 30
44
25
31
28
44
16
25 31
28