Great Plains 7344 Series VII Field Cultivator-Rigid Hitch Operator Manual - Manual (Page 24)

Section 1: Assembly
Table of Contents ► Great Plains Mfg., Inc.
Series VII 7332-7344 Field Cultivator, Rigid Hitch 560-198M 1/31/2005
22
Center Wing Stop / Outside Wing Stop Assembly
U-bolt the center wing stop (1) to the
second bar from the rear on the center frame as
shown in Figure 11. Use 5/8 x 4 x 4¼ u-bolts
(2) with lock washers and hex nuts. Center the
wing stop from side to side. Insert the ½ x 4½
transport lock quick pins (3) in the holders on
the wing stop.
On models 7341 and 7344, u-bolt the
wing lock mount (4) on the inside wing with ½
x 3 x 5 u-bolts (5). U-bolt the wing lock “T”
bracket (9) on the outside wing with the same
½ x 3 x 5 u-bolt (5). Refer to the shank layout
for your particular model for the exact location
of the wing lock mount and lock “T” bracket.
Use lock washers and hex nuts on these u-
bolts. Bolt the wing latch (6) to the wing lock
mount (4) with a ¾ x 4½ bolt (7). Slide a ¾
flat washer (8) between the latch and the
mount on each side to take out the slop. Use a
¾” two-way lock nut but do not torque down.
The latch must move freely.
Insert the rear stand leg (10) into the
frame mount bracket (11) and pin together
with ¾ x 4 ½ pin (12). U-bolt the whole
assembly to the rear bar of the center frame
with two 5/8 x 4 x 4¼ u-bolts (13) with lock
washers and hex nuts.
Figure 11