B&G H2000 Pilot *DISCONTINUED* - Manual (Page 102)

h2000 Autopilot User Manual
Part 4 - Installation Information
HB-0842-04
4-24
4.6 USING A NON-B&G SPEED SENSOR
The speed sensor must have a speed signal output from a Hall-
effect device giving positive pulses up to a maximum of 12V.
(1) Locate the cable from the speed sensor to the
instrument input.
(2) Cut cable (if necessary) and insert a junction box
(B&G Part No. 288-00-001). Connect like colour to like
colour.
(3) Use a length of 2-core screened cable (B&G Part
No. 135-0B-098 9m/29.5ft) to connect the speed signal
and ground of the paddle sensor to the speed input of the
Autopilot computer unit.
(4) Calibrate the speed input in accordance with the
instructions given in Part 3 of this manual.
Fig 4.19 Non-B&G Paddle Connection