B&G H2000 Pilot *DISCONTINUED* - Manual (Page 63)

h2000 Autopilot User Manual
Part 3 - Commissioning and Calibration
HB-0842-04
3-9
3.3.3 Heading Source (Compass) H SRC
The Heading Source setting defines the source for compass data.
This setting is determined by the type of heading sensor
connected to the system.
Most systems will use the Halcyon 2000 compass unit. The
compass sensor supplies heading data via the Fastnet cable to the
autopilot and instruments. However, some systems may have a
Halcyon Gyro Sensor fitted. This could be in addition or in lieu of
the Halcyon 2000 compass. Settings are available to select any of
the compass sensors, select the correct one for the system from
the table below:
H SRC COMPASS DATA
5 Super Halcyon 3, connected via the h2000
instrument system
9 NMEA Data input into Hercules Performance
Processor
15 Halcyon Gyro Stabilised Compass System
15 NMEA Data input into Halcyon Gyro Processor
16 Halcyon 2000 Compass
18 Gyro Sensor Connected to Autopilot ACP
Processor
96* NMEA Data input into NMEA FFD
* NMEA FFDs are sequentially numbered
dependent on the number of displays connected
to the system; i.e. 96, 97, 98 . . .
Table 3.1 Compass Data
3.3.4 Setting the Heading Source Value
(1) Select H SRC from the menu.
(2) Select the value from the table.
(3) Press Enter to store the value.