B&G H2000 Pilot *DISCONTINUED* - Manual (Page 42)

h2000 Autopilot User Manual
Part 2 - Operating Information
HB-0842-04
2-30
(3) When B SPD or SOG are selected, press the key
next to the ENTER legend. Continue with set-up or press
the key next to the EXIT legend to return to the normal
Autopilot display.
(4) When F SPD is selected press the key next to the
ENTER legend and proceed with steps (5) and (6) to set
the fixed speed value.
(5) Use the keys shown to adjust the value in
increments of 0.5 to the desired fixed speed within the
range 0.5 to 60.0.
Note
The default value for a sailboat is 8.0 knots and 25.0
knots for a powerboat.
(6) Press the key next to the ENTER legend to set the
fixed speed value. Continue with set-up or press the key
next to the EXIT legend to return to the normal Autopilot
display.
2.8.6 Off Course Set-Up (OFF C)
The OFF C set-up selects the Autopilot Display to show either off
course or rudder angle when the Autopilot is engaged in COMP,
WIND, OPT W or WAYPT modes of steering. There are two
options available:
(a) ON - The bar display shows OFF COURSE (default).
(b) OFF - The bar display shows RUDDER.
To set-up OFF C:
(1) Press the key shown until OFF C is displayed.