Bio-Rad Mini Trans-Blot® Cell - Manual (Page 9)

Mini-Trans-Blot Electrophoretic Transfer Cell 3
1.1 Specifications
Construction
Electrode module Molded polysulfone
Gel holder cassettes Molded polycarbonate
Electrodes Platinum wire 0.254 mm
diameter
Buffer chamber and lid Molded polycarbonate
Cooling unit Polyethylene
Overall dimensions
Mini Trans-Blot cell 16 (L) x 12 (W) x 18 (H) cm
Gel holder dimensions 10 x 11 cm
Maximum gel size 7.5 x 10 cm
Buffer capacity
With cooling unit 950 ml
Without cooling unit 1,150 ml
Cleaning Use mild soap and warm
water to clean the electrodes,
cassettes, and buffer tank.
Use special care when
cleaning the electrode cards.
Avoid stretching or breaking
the platinum wires. Do not
use abrasives or strong
detergents. Rinse the fiber
pads under hot water and
then in distilled, deionized
water.
Chemical compatibility The Mini Trans-Blot cell
components are not
compatible with chlorinated
hydrocarbons (e.g.,
chloroform), aromatic
hydrocarbons (e.g., toluene,
benzene), or acetone. Use of
organic solvents voids all
warranties.