Bio-Rad Components for Older Model Spot Cutter User Manual
Page 29
Section 6
Accessories
6.1
Use of Gel Sheets and Gel Positioning
The Gel Sheets (reorder part number 165-7018) are designed to be used with individual gels for
both handling and for protecting the thick plastic Cutting Mat on the spot cutter platform. The Gel
Sheet has a thin protective film on it. Peel this film off the Gel Sheet before use. When the gel is in
a container of water, pick up the gel and place it on the Gel Sheet on the bench. The Gel Sheet
and gel are then placed on the Cutting Mat, positioned towards the right side of the cutting
platform on the spot cutter, near the microtiter plate.
A Gel Holding Bar should be positioned on the top and bottom sides of the gel or blot, resting on
the edge of the gel and on the plastic Gel Sheet.
6.2
Common Re-order Parts
D
De
es
sc
crriip
pttiio
on
n
C
Ca
atta
allo
og
g n
nu
um
mb
be
err
Gel Sheets (thin plastic disposable sheets)
165-7018
Cutting Mat (thick plastic sheet - approx. 3
–4 mm thick)
165-7019
1.5 mm nominal Cutting Tip
165-7011
1.0 mm nominal Cutting Tip
165-7010
Section 7
Maintenance
7.1
General Upkeep and Cleaning
For general cleaning of the Enclosure, wipe with a damp cloth or sponge. Mild detergents or
ethanol may be used. Do not use any harsh solvents, or cleaners.
7.2
Technical Service
For technical assistance with the system including all hardware and software, contact your local
Bio-Rad office. Spare parts not listed in this document can be ordered by contacting your local
Bio-Rad office.
For inquiries and requests regarding system repair or service, contact your local Bio-Rad office or
distributor. Please have the following details available:
1. Instrument model and catalog number.
2. Serial number (located on the back of the Enclosure).
3. Hardware and software version information.
26