Bio-Rad Components for Older Model Spot Cutter - Manual (Page 8)

Fig. 5. Right side mounting brackets inside the Enclosure.
3. Using the two large thumbscrews, attach the front light assembly bracket to the front
mounting bracket. Tighten the two thumbscrews by hand.
Fig. 6. Installing the UV light assembly.
4. Repeat steps 1 –3 for the left side light assembly on the left inside of the Enclosure.
5. For each light, plug the UV light assembly power clip into the clip socket in the panel on
the back of the Enclosure. There is one clip socket for each side.
Fig. 7. Clip socket. Fig. 8. Light assembly plugged into the clip
socket.
5
Front mounting bracket
Mounting screw
Back mounting bracket