Dell OptiPlex 760 - Manual (Page 129)

4. Pull the cable release tab to disconnect the data cable from the system board.
5. Pull the drive release latch and slide the floppy drive towards the back of the computer. Then lift up to remove the drive.
6. Gently lift the data cable from the floppy data cable edge connector.
7. Replace the computer cover (see Replacing the Computer Cover ).
Installing a Floppy Drive
1. If you are:
l Installing a new floppy drive, remove the drive panel insert.
l Replacing a drive, remove the floppy drive (see Removing a Floppy Drive ).
2. Align the screws on the drive with the bracket slots in the computer and gently position the drive until it clicks into place.
3. Insert the data cable into the cable release tab on the floppy drive and press down on the tab until it clicks to lock it in place.
4. Insert the data cable into the connector on the system board.
CAUTION: Do not pull the drive out of the computer by the drive cables. Doing so may cause damage to cables and the cable connectors.
1 cable release tab 2 data cable edge connector
1 floppy drive 2 screws (3)
3 bracket slots (3)