Heat sink assembly, Removing the heat sink assembly, Installing the heat sink assembly – Dell OptiPlex 760 User Manual
Page 45
Back to Contents Page
Dell™ OptiPlex™ 760 Service Manual
Heat Sink Assembly
Removing the Heat Sink Assembly
1.
Loosen the captive screws on each side of the heat sink assembly.
2.
Rotate the heat sink assembly upward, and remove the assembly from the computer.
Lay the heat sink down on its top.
Installing the Heat Sink Assembly
1.
Place the heat sink assembly back onto the heat-sink assembly bracket.
2.
Rotate the heat sink assembly down towards the computer base and tighten the two captive screws.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING:
To guard against electrical shock, always unplug your computer from the electrical outlet before removing the computer cover.
WARNING:
Despite having a plastic shield, the heat sink assembly may be very hot during normal operation. Be sure that it has had sufficient
time to cool before you touch it.
1 heat sink assembly 2 captive screw housing (2)
CAUTION:
Ensure that the heat sink assembly is correctly seated and secure.