Dell OptiPlex 760 - Manual (Page 152)

AC Recovery Determines how the system responds when AC power is re-applied after a power loss. You can set the AC Recovery to:
l Power Off (default)
l Power On
l Last State
Auto On Time Sets time to automatically turn on the computer.
Time is kept in the standard 12-hour format (hours:minutes:seconds).
Change the startup time by typing the values in the time and AM/PM fields.
NOTE: This feature does not work if you turn off your computer using the switch on a power strip or surge protector or if Auto Power
On is set to disabled.
Low Power Mode Enables or disables low power mode.
This option is disabled by default.
NOTE: When low power mode is enabled, the integrated network card is disabled.
Remote Wakeup Allows the system to power up when a network interface controller receives a wake up signal. You can set Remote Wakeup to:
l Disable (default)
l Enable
l Enable with Boot NIC
Suspend Mode Sets the power management suspend mode to:
l S1
l S3 (default)
Fan Control
Override
Controls the speed of the system fan.
NOTE: When enabled, the fan runs at full speed.
Maintenance
Service Tag Displays the Service Tag of your computer.
Asset Tag Allows you to create a system asset tag if an asset tag is not already set.
This option is not set by default.
SERR Messages Controls the SERR Message mechanism.
This option is enabled by default.
Some graphics cards require the SERR Message mechanism be disabled.
Image Server
Lookup Method Specifies how the ImageServer looksup the server address.
l Static IP
l DNS
NOTE: You must set the Integrated NIC to Enable with ImageServer to set the Lookup Method.
ImageServer IP Specifies the primary static IP address of the ImageServer with which the client software communicates.
The default IP address is 255.255.255.255
NOTE: You must set the Integrated NIC to Enable with ImageServer to set the ImageServer IP.
ImageServer Port Specifies the primary IP port of the image server with which the client software communicates.
The default IP port is 06910.
Client DHCP Specifies how the client obtains the IP address.
l Static IP
l DHCP (default)
Client IP Specifies the static IP address of the client.
The default IP address is 255.255.255.255