Installing the sideplane board, Figure 3-33 – Dell POWEREDGE 2950 User Manual
Page 102
102
Installing System Components
Figure 3-33.
Sideplane Removal and Installation
Installing the Sideplane Board
CAUTION:
Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. See your Product Information Guide for complete information about safety
precautions, working inside the computer, and protecting against electrostatic discharge.
1 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2 Align the two guides on the sideplane board with the two pins on the SAS backplane board, and gently
lower the sideplane so that the sideplane connector is fully seated into the SAS backplane board
connector. See Figure 3-33.
3 Reattach any cables to the sideplane board.
4 If applicable, replace the storage controller daughter card. See "Installing a SAS Controller Daughter
5 Close the system. See "Closing the System" on page 55.
1
sideplane board
2
sideplane release tabs (2)
3
guides (2)
4
backplane connector
5
pins (2)
1
2
5
3
4
Book.book Page 102 Friday, February 3, 2006 11:09 AM