Installing the optical drive, Out of the system. see figure 3-21 – Dell POWEREDGE 2950 User Manual
Page 82
82
Installing System Components
Figure 3-21.
Removing and Installing the Optical Drive Tray
Installing the Optical Drive
1 Align the optical drive tray with its opening in the front panel.
The optical drive opening is above the hard-drive slots on the far right, or the flex bay, depending on
your system’s drive configuration (the hard-drives slots are identified by labels on the front panel of the
system).
2 Slide in the drive tray until the tray snaps into place. See Figure 3-21.
3 Connect the optical drive cable to the connector on the back of the drive.
4 Close the system. See "Closing the System" on page 55.
5 Replace the bezel. See "Replacing the Front Bezel" on page 54.
6 Reconnect your system and peripherals to their electrical outlets, and turn on the system.
1
optical-drive cable
2
optical-drive release tab
3
optical -drive tray
4
optical drive
2
4
3
1
Book.book Page 82 Friday, February 3, 2006 11:09 AM