Dell POWEREDGE 2950 User Manual

Page 30

Advertising
background image

30

About Your System

Error: Incorrect memory

configuration. DIMMs must

be installed in pairs of

matched memory size,

speed, and technology.

Mismatched or unmatched DIMMs
installed; faulty or improperly seated
memory module(s).

Ensure that all pairs of memory modules
are of the same type and size and that
they are properly installed. See "System
Memory" on page 89. If the problem
persists, see "Troubleshooting System
Memory" on page 120.

Error: Memory failure

detected. Memory size

reduced. Replace the

faulty DIMM as soon as

possible.

Faulty or improperly seated memory
module(s).

See "Troubleshooting System Memory"
on page 120.

!!*** Error: Remote Access

Controller initialization

failure*** RAC virtual USB

devices may not be

available...

Remote Access Controller
initialization failure

Ensure that the Remote Access
Controller is properly installed. See
"Installing a RAC Card" on page 80.

FBD training error: The

following branch has been

disabled: Branch x

The specified branch (channel pair)
contains DIMMs that are
incompatible with each other.

Ensure that only Dell-qualified memory
is used. Dell recommends purchasing
memory upgrade kits directly from
www.dell.com or your Dell sales agent to
ensure compatibility.

Gate A20 failure

Faulty keyboard controller; faulty
system board.

See "Getting Help" on page 147.

General failure

The operating system is unable to
carry out the command.

This message is usually followed by
specific information. Note the
information, and take the appropriate
action to resolve the problem.

Invalid NVRAM

configuration, Resource

Re-allocated

System detected and corrected a
resource conflict.

No action is required.

Keyboard Controller

failure

Faulty keyboard controller; faulty
system board

See "Getting Help" on page 147.

Manufacturing mode

detected

System is in manufacturing mode.

Reboot to take the system out of
manufacturing mode.

MEMBIST failure - The

following DIMM/rank has

been disabled by BIOS:

DIMM x Rank y

Faulty memory module(s).

See "Troubleshooting System Memory"
on page 120.

Table 1-7.

System Messages (continued)

Message

Causes

Corrective Actions

Book.book Page 30 Friday, February 3, 2006 11:09 AM

Advertising