Dell POWEREDGE 2950 - Manual (Page 55)

Installing System Components
55
Closing the System
1 Lift up the latch on the cover.
2 Place the cover on top of the system and offset the cover slightly back so that it clears the chassis J
hooks and lays flush on the system chassis. See Figure 3-3.
3 Push down the latch to lever the cover into the closed position.
4 Rotate the latch release lock in a clockwise direction to secure the cover.
Figure 3-3. Removing the Cover
Hard Drives
This subsection describes how to install and configure SAS or SATA hard drives in the system's internal
hard-drive bays. Your system features up to six 3.5-inch hard drives, or eight 2.5-inch hard drives. All drives
connect to the system board through one of three optional SAS backplane boards. See "SAS Backplane
Board Connectors" on page 139 for information on these backplane options.
NOTE:
Depending on the hard drive configuration you ordered, your hard drive(s) may come with a drive interposer
that allows your SATA drive to attach to the SAS connector on the backplane.
1 latch 2 latch release lock 3 alignment J hooks
1
3
2
Book.book Page 55 Friday, February 3, 2006 11:09 AM