NISSAN 2015 Murano - Owner's Manual User Manual

Page 167

Advertising
background image

Auto Reverse:
If an obstacle is detected during power open or
power close, a warning chime will sound and the
liftgate will reverse direction and return to the full
open or full close position. If a second obstacle is
detected, the liftgate motion will stop and the
liftgate will enter manual mode.

A pinch strip is mounted on each side of the
liftgate. If an obstacle is detected by a pinch strip
during power close, the liftgate will reverse direc-
tion and return to the full open position.

NOTE:

If the pinch strip is damaged or removed,
the power close function will not operate.

WARNING

There are some small distances immedi-
ately before the closed position which
cannot be detected. Make sure that all
passengers have their hands, etc., inside
the vehicle before closing the liftgate.

Manual Mode:
If power operation is not available, the liftgate
may be operated manually. Power operation may
not be available if the power liftgate main switch
is in the ON position, if multiple obstacles have
been detected in a single power cycle, or if
battery voltage is low.

If the power liftgate opener switch is pushed
during power open or close, the power operation
will be canceled and the liftgate can be operated
manually.

To open the liftgate manually, press the liftgate
opener switch and lift the liftgate.

To close, lower and push the liftgate down se-
curely.

Auto Power Back Door System Battery
Power Saving Mode:
The vehicle goes into power saving mode when
the liftgate is open for a long time (approximately
12 hours). This is to prevent deterioration of the
battery. The power saving mode automatically
cuts the power supply of the power liftgate door.

When the power to the liftgate is cut off, the
manual mode must be performed. After the
manual mode is performed, the power liftgate
function is restored.

NOTE:

When a battery voltage is lower than ap-
proximately 11V, the power back door may
not operate after automatic return.

LPD2297

3-24

Pre-driving checks and adjustments

Advertising