NISSAN 2015 Murano - Owner's Manual - Manual (Page 178)

this manual, and “Tilt/Telescopic Steering”
and “Outside mirrors” in this section.
3. Push the SET switch and, within 5 seconds,
push the memory switch (1 or 2).
4. The indicator light for the pushed memory
switch will come on and stay on for approxi-
mately 5 seconds.
5. The chime will sound if the memory has been
stored.
NOTE:
If a NEW memory position is stored in the
same memory switch, the previous memory
position will be overwritten by the new
stored position.
Confirming memory storage
Push the SET switch.
● If a memory position has not been stored in
the switch (1 or 2) the indicator light for the
respective switch will come ON for approxi-
mately 0.5 seconds.
● If a memory position has been stored in the
switch (1 or 2) then the indicator light for the
respective switch will stay on for approxi-
mately 5 seconds.
Linking a key fob to a stored memory
position
Each key fob can be linked to a stored memory
position (memory switch 1 or 2) with the follow-
ing procedure.
1. Follow steps 1–3 listed in Memory Storage
Function in this section for storing the
memory position.
2. The indicator light for the pushed memory
switch will come ON, while the indicator
light is ON for 5 seconds, press the
button on the key fob. The indicator light of
the linked memory switch will blink. After the
indicator light goes off, the key fob is linked
to that memory setting.
Once it is linked, when the ignition switch is
placed in the OFF position, pressing the
button on the key fob will move the driver’s seat,
steering wheel and outside mirrors to the linked
memory switch position.
NOTE:
If a NEW memory positon is stored int he
linked memory switch then the key fob will
link to the NEW position and overwrites the
previous position.
The system contains a ON/OFF setting for when
the settings are not to be memorized.
Linking an Intelligent Key to the meter
display (if so equipped)
Each Intelligent Key, up to a maximum of four, can
be linked to the meter display.
1. When the system is enabled, the recognized
Intelligent Key is displayed at start up, as well
as within “Key Link Settings”.
2. When the system is active, the meter setting
items are memorized for each Intelligent Key
that has been enabled in the system.
3. The auto drive positioner system is memo-
rized automatically when the ignition switch
is turned from ON to OFF by the Intelligent
Key with no need to set separate buttons for
recalling and memorizing positions.
4. If two Intelligent Keys are in the vehicle, the
system will recognize the Intelligent Key that
was used most recently, such as to
unlock/lock the door.
Pre-driving checks and adjustments 3-35