NISSAN 2015 Murano - Owner's Manual - Manual (Page 272)

The RCTA system uses radar sensors
᭺
1 in-
stalled on both sides near the rear bumper to
detect an approaching vehicle.
The radar sensors
᭺
1 detect an approaching
vehicle from up to approximately 66 ft. (20 m)
away.
If the radar detects a vehicle approaching from
the side, the system gives visual and audible
warnings.
How to enable/disable the RCTA
system
Perform the following steps to enable or disable
the RCTA system.
1. Press the button until “Settings” dis-
plays in the vehicle information display. Use
the
button to select “Driver Assis-
tance”. Then press the ENTER button.
2. Select “Blind Spot” and press the ENTER
button.
3. To set the BSW/RCTA system to on or off,
use the buttons to navigate in the
menu and use the ENTER button to select or
change an item:
● Select “Blind Spot” and press the ENTER
button.
– To turn on the warning, use the ENTER
button to check box for “BSW system”
NOTE:
The RCTA system is integrated into the
BSW system. There is not a separate selec-
tion in the vehicle information display for
the RCTA system. When the BSW is dis-
abled, the RCTA system is also disabled.
LSD2216
Starting and driving 5-27