NISSAN 2013 Quest - Owner's Manual - Manual (Page 137)

Black plate (133,1)
[ Edit: 2013/ 3/ 26 Model: E52-D ]
Tilting
To tilt up, first close the moonroof, then push the
switch to the tilt up position
*
B and release it; it
does not need to be held. To tilt down the
moonroof, push the switch to the tilt down
position
*
A .
Locking
When the window lock button is pushed in, the
rear moonroof cannot be operated. When the
window lock position is pushed off, the rear
moonroof can be operated. (See “Power win-
dows” (P.2-51).)
Auto-reverse function
WARNING
There are some small distances imme-
diately before the closed position which
cannot be detected. Make sure that all
passengers have their hands, etc., in-
side the vehicle before closing the
moonroof.
If the control unit detects something caught in
the moonroof when it is closing, the moonroof
will be immediately opened.
The auto reverse function can be activated when
the moonroof is closed by automatic operation
when the ignition switch is in the ON position or
for about 45 seconds after the ignition switch is
pushed to the OFF position.
If the moonroof cannot be closed automatically
when the auto reverse function activates due to
a malfunction, push and hold the moonroof
switch to the close position
*
B .
Depending on the environment or driving
conditions, the auto reverse function may
be activated if an impact or load similar to
something being caught in the moonroof
occurs.
IF THE FRONT OR REAR MOONROOF
DOES NOT OPERATE
If the front or rear moonroof does not operate
properly, perform the following procedure to
initialize the moonroof operation system. Initiali-
zation can be performed for both the front
moonroof and rear moonroof.
1. If the moonroof is open, close it fully by
pushing and holding the moonroof switch to
the close position
*
B until the moonroof
tilts up.
2. Release the moonroof switch, then push and
hold the *
B side again for more than 10
seconds.
3. Release the moonroof switch, then continue
to push on the *
B side again. The moonroof
will operate in the close direction. (The
moonroof operates inch by inch.)
4. After the moonroof stops moving, release
the moonroof switch and within 4 seconds,
push side
*
B again. The moonroof will
automatically open once.
5. Within 0.5 seconds after the moonroof
stops moving, release the moonroof switch.
6. Check that the moonroof now operates
normally.
If the moonroof does not operate properly after
performing the procedure above, have your
vehicle checked by a NISSAN dealer.
Instruments and controls 2-55
Condition: