NISSAN 2013 Quest - Owner's Manual - Manual (Page 231)

Black plate (227,1)
[ Edit: 2013/ 3/ 26 Model: E52-D ]
Automatic operation (AUTO)
The AUTO mode may be used year-round as the
system automatically controls constant tempera-
ture, air flow distribution and fan speed after the
desired temperature is set manually.
To turn the heater and air conditioner on or off,
push the “ON·OFF” button.
Cooling and dehumidified heating:
1. Push the “AUTO” button.
(The AUTO indicator light will illuminate.)
2. If the A/C indicator light does not illuminate,
push the “A/C” button.
(The A/C indicator light will illuminate.)
3. Push the temperature control buttons
(“ ” and “ ”) (driver’s side) to set the
desired temperature.
. The temperature can be set within the
range of 60 to 908F (18 to 328C).
. When “DUAL” does not appear on the
display:
— Pushing the “AUTO” button changes
both the driver’s and front passenger’s
side temperature.
— Pushing the “DUAL” button allows the
user to independently change the front
passenger’s side temperature with the
passenger side temperature control but-
tons (“ ” and “ ”). (“DUAL” will
appear on the display.)
To cancel the separate temperature
setting, push the “DUAL” button (“DUAL”
will disappear from the display) and the
driver’s side temperature setting will be
applied to both the driver’s and front
passenger’s sides.
4. Models with Advanced Climate Control
System:
. Push the “ AUTO” auto-recirculation
button. The indicator light on the “
AUTO” auto-recirculation button will illu-
minate. In this mode, the sensor detects
odors and gas to automatically switch
between the air recirculation mode and
the outside air circulation mode. (See
“Advanced climate control system” (P.4-
50) for details.)
Models without Advanced Climate Control
System:
. Push and hold the air recirculation “ ”
button or outside air circulation “ ”
button (the one with the indicator light
on) for more than 2 seconds to set the
automatic control between the air recir-
culation and outside air circulation
modes. (The “
” and “ ” indicator
lights will blink twice.)
The following conditions need to be met for the
automatic air intake control mode to function
properly.
. The air flow control is not in the front
defroster mode (the indicator light on the
front defroster “
FRONT” button is
turned off).
. The outside temperature is approximately
328F (08C) or above.
A visible mist may be seen coming from the
ventilators in hot, humid conditions as the air is
cooled rapidly. This does not indicate a mal-
function.
Heating (A/C off):
1. Push the “AUTO” button.
(The AUTO indicator light will illuminate.)
2. If the A/C indicator light illuminates, push the
“A/C” button.
(The A/C indicator light will turn off.)
3. Push the temperature control buttons
(“ ” and “ ”) (driver’s side) to set the
desired temperature.
When the DUAL mode is turned off (“DUAL”
does not appear on the display):
. Pushing the “AUTO” button changes
both the driver’s and front passenger’s
side temperature.
Monitor, heater, air conditioner, audio, phone and voice recognition systems 4-47
Condition: