NISSAN 2013 Quest - Owner's Manual - Manual (Page 263)

Black plate (259,1)
[ Edit: 2013/ 3/ 26 Model: E52-D ]
SAA3600
iPod ® player operation
Connecting iPod ® :
The USB outlet connector is located in the
center console. Open the USB port cover and
connect the iPod
® cable to the USB connector.
The battery of the iPod ® is charged while the
connection to the vehicle.
Depending on the version of the iPod ® , the
display on the iPod ® shows a NISSAN or
Accessory Attached screen when the connec-
tion is completed. When the iPod
® is connected
to the vehicle, the iPod ® music library can only
be operated by the vehicle audio controls.
* iPod ® and iPhone ® are a trademark of Apple
Inc., registered in the U.S. and other countries.
CAUTION
. Do not force the iPod ® cable into
the USB port. Inserting the iPod ®
cable tilted or up-side-down into the
port may damage the iPod
® cable
and the port. Make sure that the
iPod
® cable is connected correctly
into the USB port. (Some iPod ®
cable come with a mark as a
guide. Make sure that the mark is
facing the correct direction before
inserting the iPod
® cable.)
. Do not locate objects near the iPod ®
cable to prevent the objects from
leaning on the iPod
® cable and the
port. Pressure from the objects may
damage the iPod
® cable and the
port.
Compatibility:
The following models are available:
. Third generation iPhone ® (Firmware version
IOS4/4.0)
. Fourth generation iPhone ® (Firmware ver-
sion IOS4/4.0)
. Fifth generation iPod ® (Firmware version
1.3)
. First generation iPod Classic ® (Firmware
version 1.1.1 or 1.1.2PC)
. Second generation iPod Classic ® (Firmware
version 2.0.1)
. First generation iPod touch ® (Firmware
version 1.1.5 or 2.2.1)
. Second and third generation iPod touch ®
(Firmware version 2.2.1 or IOS4/4.0.0)
. First generation iPod nano ® (Firmware ver-
sion 1.3.1)
. Second generation iPod nano ® (Firmware
version 1.1.3)
. Third generation iPod nano ® (Firmware
version 1.1.2PC or 1.1.3PC)
. Fourth generation iPod nano ® (Firmware
version 1.0.2 or 1.0.4)
. Fifth generation iPod nano ® (Firmware ver-
sion 1.0.1 or 1.0.2)
The iPod touch ® may not response quickly with
the system in some cases.
Make sure that the iPod ® firmware is updated.
Audio main operation:
Place the ignition switch to the ACC or ON
position. Then, push the CD·AUX button repeat-
edly to switch to the iPod
® mode.
If the system has been turned off while the iPod ®
Monitor, heater, air conditioner, audio, phone and voice recognition systems 4-79
Condition: