NISSAN 2013 Quest - Owner's Manual - Manual (Page 226)

Black plate (222,1)
[ Edit: 2013/ 3/ 26 Model: E52-D ]
4-42 Monitor, heater, air conditioner, audio, phone and voice recognition systems
Controls
To turn off the heater and air conditioner, push
the “ON·OFF” button.
Fan speed control:
Push the fan speed control button “
” to
increase the fan speed.
Push the fan speed control button “ ” to
decrease the fan speed.
A/C (Air Conditioner) operation:
Push the A/C button to turn on or off the air
conditioner. When the air conditioner is on, the
A/C indicator light on the button illuminates.
Air flow control:
Push the “MODE” button to change the air flow
mode.
: Air flows from the center and side ventila-
tors.
: Air flows from the center and side ventila-
tors, and foot outlets.
: Air flows mainly from the foot outlets.
: Air flows from the defroster and foot outlets.
Temperature control:
Push the temperature control buttons (“
”
and “ ”) to set the desired temperature.
Air recirculation:
Push the air recirculation “
” button to
recirculate interior air inside the vehicle. The
indicator light on the air recirculation “
”
button will illuminate.
The air recirculation mode cannot be activated
when the air conditioner is in the front defrosting
mode.
Outside air circulation:
Push the outside air circulation “
” button to
draw outside air into the passenger compart-
ment. The indicator light on the outside air
circulation “
” button will turn on.
Heater operation
Heating:
This mode is used to direct heated air to the foot
outlets.
1. Push the outside air circulation “ ” button
to switch to the outside air circulation mode.
(The indicator light turns on.)
2. Push the air flow control button to change to
the mode.
3. Push the fan speed control buttons to set
the desired fan speed.
4. Push the temperature control buttons to set
the desired temperature between the middle
and the hot position.
Ventilation:
This mode directs outside air to the side and
center ventilators.
1. Push the outside air circulation “ ” button
to switch to the outside air circulation mode.
(The indicator light turns on.)
2. Push the air flow control button to change to
the mode.
3. Push the fan speed control buttons to
set the desired position.
Bi-level heating:
This mode directs cool air from the side and
center vents and warm air from the foot outlets.
When the temperature is set to the maximum hot
or cool position, the air between the ventilators
and the foot outlets is the same temperature.
1. Push the outside air circulation “ ” button
to switch to the outside air circulation mode.
(The indicator light turns on.)
2. Push the air flow control button to change to
the mode.
3. Push the fan speed control buttons to set
the desired fan speed.
4. Push the temperature control buttons to set
the desired temperature.
Condition: