Vermont Casting DV580 - Manual (Page 25)

25
DV360/580 Series Direct Vent Gas Fireplace
20010667
DV360
H100a
hearth Panels
1/27/00 djt
Screw Burner
Hearth Panels
Grate
Front of Unit
H100a
Screw
Fig. 48 Hearth panel location.
Installation of Logs
Remove front glass. (Refer to “Window Frame As-
sembly Removal” Section, Fig. 47) Remove logs from
packaging.
As with all plastics — these are not toys
and should be kept away from children
and infants.
Log Identification Chart
Logs DV360 DV580
Log Front Left 20010673 E9
Log Front Right 20010672 E10
Log Rear 20010675 E8
Log Top Left -- E12
Log Top Right 20010676 E13
Log Front Center -- E11
Log Top Center 20010677 --
Log Overlay 20010674 --
NOTE: Refer to Figure 49 for bracket and bend loca-
tions.
1. Place the log front right. Hold the log with the pointed
end toward the left. Place on top of burner toward
the right. Slide the log toward the front until it comes
in contact with the bracket at the front of the burner
housing behind the burner tube. (Fig. 49) Adjust the
log until the pointed end on the left is aligned with
the left edge of the bracket. (Fig. 50) NOTE: Gently
push down on the right rear of the log so the pilot
front shield cuts slightly into the log. This will help to
ensure proper log position.
������
���������������������
����
Log Front Right
LG477
Figure 50
Front Brackets
������
������������
����
Stop
Bracket
Rear Log
Bracket
Pilot
Bracket
Bend
Front Left
Bend
Front
Brackets
FP1653
Fig. 49 Burner brackets and bends.
Left Edge
of Bracket
Pilot Front
Shield