Vermont Casting DV580 - Manual (Page 50)

50
DV360/580 Series Direct Vent Gas Fireplace
20010667
Remote Controls
Optional remote control units are available to control
different functions of the appliance.
Model Functions Controlled
RC1 ON/OFF
RC2 ON/OFF and Temperature
IMTFK Wall mounted thermostat control
Ceramic Refractory Panels
Ceramic refractory panels are available to line the fire-
box area.
Unit Kit Model
DV360 DV360CRSS Sandstone
DV360 DV360CRR Red
DV360 DV360CRB Black
DV360 DV360CRG Grey
DV580 DV580CR
Take care when handling the refractory
panels as they are fragile until held in
place and supported.
Installation Instructions
1. Remove window frame assembly and logs.
2. Remove three (3) screws securing heat shield to
combustion dome. (Fig. 82)
3. Place rear ceramic panel in back of unit. (Fig. 83)
4. Place side panels.
5. Replace heat shield, logs and window frame assem-
bly.
H102
rear ceramic support
2/23/99 djt
Rear Ceramic Panel
Back of
Firebox
Burner
Rear Log
Support
H102
Fig. 83 Rear ceramic panel placement.
Decorative Bay Windows
The bay window kit is available for the DV360 only.
Installation
Remove the existing louvre assembly top.
Assemble the Bay Window Kit according to the instruc-
tions supplied with the kit. (Fig. 84)
FP1194
Install bay
window
2/19/02 djt
Upper Grille Assembly
Ceramic
Refractory
Ceramic
Refractory
Window
Assembly
Base Grille
Assembly FP1194
Fig. 84 Bay window.
Decorative Frame Trims
A selection of decorative frame trim kits are available for
mounting around the outside of the appliance to en-
hance its visual effect on the room. Installation instruc-
tions for each decorative frame trim are included with
the frame trim kit. Contact your authorized distributor for
details of the trim kits and ordering information for the
trim kits applicable to this model appliance.
H103
heat shield
3/1/99 djt
Heat Shield
Section A
Heat Shield
(3)
Screws
H103
Fig. 82 Heat shield.
Side View
Section A