Vermont Casting DV580 - Manual (Page 26)

26
DV360/580 Series Direct Vent Gas Fireplace
20010667
�����
�������������
����
LG478
Log Overlay
Figure 51
�����
������������
����
2. Place the log overlay. Hold the overlay with the flat
side down and large cut out for the middle flame
on the right. Set the overlay on top of the burner
toward the left front inside the stop bracket on
the left end and the bend on the front left of the
burner. (Fig. 49) Rotate the right end of the
overlay clockwise until it makes contact with
the back of the log front right. NOTE:
This is very critical as improper
positioning of the overlay will
affect the flame and the per-
formance of the unit. (Fig. 51)
3. Place log rear. The rear log sits
in the firebox at an angle toward
the left over the rear log bracket
and the left side of the burner.
(Fig. 49) Set the log on the rear
log bracket. The notch on the right
side will go over the pilot. Swing
the left end of the log toward the
front until it makes contact with the
stop bracket. Slide the log to the
right so the pilot notch on the log
makes contact with bend on the
left of the pilot bracket. (Fig. 52)
4. Place the glowing embers by
building them up lightly between
the fettle and the burner tube as-
sembly. (Fig. 53)
5. Place the log front left. Set the
log by matching the square hole
on the bottom with the pins on
the overlay. The right side of this
log should come in contact with
the left andiron. Lay the log at an
angle to the left over the fettle.
When this log is in place, it must
not cover the front left opening of
the overlay. (Fig. 54)
Glowing Embers
LG463
Figure 53
Locator Pins
�����
�����������������
����
LG462
Figure 52
Log Rear