Vermont Casting DV580 - Manual (Page 27)

27
DV360/580 Series Direct Vent Gas Fireplace
20010667
6. Place the log top cen-
ter. Hold the log with
the pointed end toward
the back. Match the two
holes on the bottom of
the log with the two pins
on the top of the log front right.
(Refer to Figure 53 for pin loca-
tions) Set the log and lay it into
the rear log. (Fig. 54)
7. Place the log top right. Hold the
log with pointed end to the left.
Match the two holes on the bot-
tom of the log with the two pins
on the rear log and set the fork
on the log over the right front
log. (Fig. 54)
8. Place the lava rock on the
hearth refractory in the front
as desired. (Fig. 54)
�����
����������
����
Log
Rear
Log Top Center
Log Top Right
Log
Front
Right
Log Front Left
Lava Rock
LG464
Figure 54
�����
����������
����
Log Top Left
(E12) Log Rear
(E8)
Log Top Right
(E13)
Log Front
Left
(E9)
Burner Lava Rock and
1/3 of the bag of Embers
Log Front
Right
(E10)
LG395
Fig. 55 DV580 log, burner lava rock and ember placement.
Log Front
Center (E11)
DV580
Refer to Figure 51.
1. Place rear log (E8) on rear
bracket (ensure the notch on
the left end is centered on
the left side of rear bracket),
so it will not move from side
to side and is firmly posi-
tioned on the bracket. Be
sure log is as far forward as
possible on bracket. (Fig. 55)
2. Place front left log (E9) on
top of burner, left side. Align
log’s bottom holes with left
bracket log locator studs.
3. Place front right log (E10)
on top of burner, right side.
Align log’s bottom holes
with right bracket log locator
studs. (Fig. 50)
4. Place top left log (E12). Use
log’s bottom hole to locate
it onto rear log left (E8) and
just rest bottom cut out log
onto the grate assembly.
5. Place top right log (E13).
Use log’s bottom hole to locate it onto rear log right
(E8) and the bottom of top right log rest onto front
right log (E10).
6. Place front center log (E11). Position the log notch
against the center grate assembly and the bottom of
front center log rest onto front right log (E10).
Top logs must be placed properly onto
notches.
7. Place large lava rock around the front grate.