Wide area 1 and 2 configuration, Utton and go to the, Wide – Cabletron Systems Cabletron CyberSWITCH CSX400 User Manual
Page 93: Area 1 and 2 configuration, Section
CSX400 Configuration with QuickSET
CSX400 and CSX400-DC User’s Guide
79
Wide Area 1 and 2 Configuration
Refer to the appropriate section listed below to configure your Wide Area 1 or 2 interface on the
CSX400:
Wide Area T1 Configuration Window
Wide Area E1 Configuration Window
Wide Area DI Configuration Window
Wide Area Synchronous Configuration Window
Wide Area DDS Configuration Window
Wide Area HDSL Configuration Window
NOTE
When configuring WAN interfaces 1 and 2 with
QuickSET, the Wide Area configuration
window that displays corresponds to the specific WPIM that is installed into the
CSX400.
NOTE
Configuration for the Wide Area 2 interface is the same as the configuration for the
Wide Area 1 interface.
Both Wide Area 1 and Wide Area 2 slots must be populated to initiate Wide Area
interface 2 configuration.