Dell XPS M2010 (MXP061, Mid 2006) User Manual
Page 108
Ensure that the cables for the microphone and keyboard are not underneath the system board.
2.
Replace the four M2.5 x 5-mm screws marked with white arrows on the system board.
3.
Replace the USB/audio port board:
a.
Insert the USB/audio port board at an angle and push down on the black connector to snap the board into place.
b.
Attach the USB/audio port board to the system board with four M2.5 x 5-mm screws.
c.
Connect the USB/audio cable to the connector on system board (JAUDIO).
4.
Connect the cable for the internal card with Bluetooth wireless technology to the connector on the system board (JBT).
5.
Connect the subwoofer cable to the connector on the system board (JWOFR).
6.
Connect the keyboard cable to the connector on the system board (JKBDK). Place the flat cable in the connector, then close the connector.
7.
Connect the microphone cable to the connector on the system board (JMIC).
8.
Replace the modem (see
Replacing the Modem
).
9.
Thread the solenoid and video cables through the opening in the computer base.
10.
Seat the computer base onto the hinge arms, aligning the screw holes in the computer base with those in the hinge arms.
11.
Connect the solenoid cable to the solenoid card.
12.
Replace the frame (see
Replacing the Frame
).
13.
Replace the processor thermal-cooling assembly (see
Replacing the Processor Thermal-Cooling Assembly
).
14.
Replace the video card/thermal-cooling assembly and connect the video cable to the video card (see
Replacing the Video Card/Thermal-Cooling
Assembly
).
15.
Replace the system fans (see
Replacing a System Fan
).
16.
Replace the hard drive(s) (see
Replacing a Hard Drive
).
17.
Replace the top cover (see
Replacing the Top Cover
).
18.
Replace the cosmetic covers (see
Replacing the Cosmetic Covers
).
19.
Firmly attach the keyboard to the computer and close the display (see
Closing the Display
).
20.
Turn the computer upside down.
21.
Replace the coin cell battery (see
Replacing the Coin-Cell Battery
).
22.
Connect the cables to the system board connectors for the speaker (JSPK), suspend and solenoid function (JHING), and infrared (JCIR).
23.
Replace the mini card antenna cables and card (see
Replacing a Mini Card
).
24.
Replace the memory module(s) and cover (see
Replacing the Memory Module
).
25.
Replace the system battery (see
Replacing the System Battery
).
26.
Turn the computer over and open the display (see
Opening the Display
).
27.
Detach the keyboard by grasping the sides of the keyboard and pulling it straight out from the computer base.
28.
Turn on the computer.
NOTICE:
To avoid damage to the keyboard, ensure that you attach the keyboard securely before moving the computer.
NOTICE:
Before turning on the computer, ensure that no stray screws remain inside the computer. Failure to do so may result in damage to the
computer.