System board, Installing the optional hard drive fan, Removing the system board – Dell XPS M2010 (MXP061, Mid 2006) User Manual
Page 86
Installing the Optional Hard Drive Fan
1.
Slide the fan between the hard drive bays until it snaps into place.
2.
Connect the fan cable to the FAN_HDD connector on the system board (see
System Board Components
).
3.
Replace the computer cover (see
Replacing the Computer Cover
).
4.
Connect your computer and devices to electrical outlets, and then turn them on.
System Board
Removing the System Board
1.
Follow the procedures in
Before You Begin
.
2.
Remove the computer cover (see
Removing the Computer Cover
).
3.
Disconnect the fan cable from the FAN_CAGE connector on the system board (see
System Board Components
).
4.
Remove any full-length expansion cards (see
Removing PCI and PCI Express Cards
).
5.
Remove the two screws securing the card fan assembly, then remove the assembly and set it aside.
1
hard-drive fan release latch
2
hard drive fan
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into your computer.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide
NOTICE:
The system board and metal tray are connected and are removed as one piece.