Mini card, Removing a mini card – Dell XPS M2010 (MXP061, Mid 2006) User Manual
Page 21
Back to Contents Page
Mini Card
Dell™ XPS™ M2010 Service Manual
Removing a Mini Card
1.
Follow the instructions in
Before Working Inside Your Computer
, including removing the system battery.
2.
With the computer still turned over, remove the memory module cover (see
Removing the Memory Module Cover
).
3.
Disconnect the antenna cables from the mini card.
4.
Release the card by pulling back on the metal securing tabs until the card pops up.
5.
Lift the card out of its connector.
CAUTION:
Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
CAUTION:
Only products approved for use in your portable computer may be installed.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface. If you leave the area, ground yourself again when you return
to the computer.
NOTICE:
To help prevent damage to the system board, remove the main battery before working inside the computer.
1
antenna cables
2
mini card
3
system board connector
1
mini card
2
metal securing tabs (2)