Fan assemblies, Control panel, Removing the control panel – Dell PowerVault 725N (Rackmount NAS Appliance) User Manual
Page 28: Installing the control panel
Control Panel
, the control panel is shown removed from the system chassis.
Figure 4-4. Control-Panel Removal
Removing the Control Panel
1.
."
2.
Remove the system cover. See "
."
3.
Remove the right-most hard drive. See "
4.
Disconnect the control panel cable from the backplane board.
5.
Remove the two retaining screws that secure the control-panel to the system chassis. See
6.
Disconnect the control panel cable from the control panel.
7.
Remove the control panel from the system chassis. See
Installing the Control Panel
1.
Connect the control-panel cable to the control panel. See
.
2.
3.
Connect the control-panel cable to the backplane. See
Fan Assemblies
The blower assembly, which is located behind IDE drive 1, contains one fan. In addition, two smaller fan assemblies are inside: one located near the processor
and heat sink.
CAUTION:
See your System Information Guide for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.
CAUTION:
See your System Information Guide for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.
CAUTION:
See your System Information Guide for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.