Removing the fan, Replacing the fan – Dell Latitude E6500 (Mid 2008) User Manual
Page 29
Back to Contents Page
Fan
Dell™ Latitude™ E6500 Service Manual
Removing the Fan
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the
Regulatory Compliance Homepage at: www.dell.com/regulatory_compliance.
1.
Follow the instructions in
Before Working on Your Computer
.
2.
Close the display and turn the computer over.
3.
Remove the bottom of the base assembly (see
Removing the Bottom of the Base Assembly
).
4.
Remove the three M2.5 x 5-mm screws that secure the fan to the base of the computer.
5.
Disconnect the fan connector from the system board.
6.
Lift the fan up at an angle to remove it.
Replacing the Fan
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the
Regulatory Compliance Homepage at: www.dell.com/regulatory_compliance.
1.
Insert the fan at an angle, and push down aligning the screws holes in the fan with the screw holes in the heat sink.
2.
Replace the three M2.5 x 5-mm screws to secure the fan to the base of the computer.
3.
Connect the fan connector to the system board connector.
4.
Replace the bottom of the base assembly (see
Replacing the Bottom of the Base Assembly
).
Back to Contents Page
1 fan
2 M2.5 x 5-mm screws (3)
3 fan connector