Dell Latitude E6500 (Mid 2008) User Manual
Page 54
17.
Replace the processor (see
Replacing the Processor Module
).
18.
Replace the processor thermal-cooling assembly (see
Replacing the Processor Thermal-Cooling Assembly
).
19.
Replace the memory modules (see
Replacing a Memory Module
).
20.
Reconnect the coin-cell battery cable (see
Replacing the Coin-Cell Battery
).
21.
Replace the hard drive (see
Replacing the Hard Drive
).
22.
Replace the WPAN card (see
Replacing a WPAN/UWB Card
).
23.
Replace the hinge covers (see
Replacing the Hinge Covers
).
24.
Replace the WLAN card (see
Replacing a WLAN/WiMax Card
).
25.
Replace the WWAN card (see
Replacing a WWAN Card
).
26.
Replace the bottom of the base assembly (see
Replacing the Bottom of the Base Assembly
).
27.
Turn on the computer.
28.
Flash update the BIOS (see
Flashing the BIOS
for more information).
29.
Enter the system setup program to update the BIOS on the new system board with the computer Service Tag. For information about the system setup
program, see the Dell™ Technology Guide on your computer or on the Dell Support website at support.dell.com.
Back to Contents Page
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
NOTE:
If you use a BIOS update program CD to flash the BIOS, press <F12> before inserting the CD in order to set the computer to boot from the
CD for one time only. Otherwise, you must enter the system setup program to change the default boot order.