Dell PowerEdge C8000 - Manual (Page 37)

Installing System Components 37
Figure 2-7. Removing and Installing a 3.5-inch Hard-Drive From a Standard Hard-Drive
Carrier
Installing a 3.5-inch Hard-Drive Into a Standard Hard-Drive Carrier
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Insert the new hard-drive into the metal shield and then align the holes on
the hard-drive with the holes on the metal shield. Make sure that the metal
shield with the arrow symbol is pointing up and the label on the drive is
facing up. See Figure 2-7.
2 Lower the hard-drive assembly into the standard hard-drive carrier. See
Figure 2-7.
1 3.5-inch hard-drive 2 metal shield
3 standard hard-drive carrier 4 strap handle
5 hard-drive carrier notch
1
2
4
5
3