Palm rest bracket, Removing the palm rest bracket – Dell Inspiron 11z (1110, Mid 2009) User Manual
Page 41
Back to Contents Page
Palm Rest Bracket
Dell™ Inspiron™ 11 Service Manual
Removing the Palm Rest Bracket
Replacing the Palm Rest Bracket
Removing the Palm Rest Bracket
1.
Follow the procedures in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the keyboard (see
Removing the Keyboard
).
4.
Remove the palm rest (see
Removing the Palm Rest
).
5.
Remove the speakers (see
Removing the Speakers
).
6.
Remove the hard drive (see
Removing the Hard Drive
).
7.
Turn the computer over and remove the four screws from the computer base.
8.
Turn the computer top-side up, open the display, and remove the four screws that secure the palm rest bracket to the computer base.
9.
Disconnect the power button cable from the system board connector.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.